Author Topic: Would anyone be able to identify this connector?  (Read 215 times)

0 Members and 1 Guest are viewing this topic.

Offline aaron94

  • Newbie
  • Posts: 2
  • Country: au
Would anyone be able to identify this connector?
« on: November 30, 2019, 05:45:19 am »
Hi  :)

Link to image: https://1drv.ms/u/s!ArCROuT6bRvPilFN2raZQIJcH6oG

I have the crimping tool already and the smaller type of these connectors that I use now and then but these are a bit bigger.

It’s from a temp controllable laminator I bought. Mains flex and supplied AU plug is unbelievable. Absolute rubbish. Earth cut off inside the metal chassis and as soon as I put the smallest amount of pull force on the connector shown in the picture, the neutral pulled out. Must have been holding on by a strand.

Rest of it is decent enough but it’s amazing there’s not more house fires with stuff like this...

Thanks!  :)
 

Offline madao

  • Regular Contributor
  • *
  • Posts: 184
  • Country: de
Re: Would anyone be able to identify this connector?
« Reply #1 on: November 30, 2019, 06:01:05 am »
Pleas upload pictures here.  I hate slow page as google drive and mircodoof (german mircostupid) onedrive.

This is a JST VH, if  Pin pitch = 3,96mm

regards
matt
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf