Electronics > Repair

xbox 360 controller not working

(1/2) > >>

david smth:
xbox 360 controller not working
Green lights are not on, there is no voltage, I tried a lot, I cleaned it with isopropyl alcohol, I put in a new battery, the result is the same, it does not start, where should I look first, I cleaned it, there was a lot of corrosion.

bborisov567:
Check if any corroded pcb traces are present. They usually have darker spots or even look darker than the rest. Check if you have any corroded components, for example a chip pin can be missing. 

david smth:
these are the pictures

david smth:
these are the pictures

stevopedia:
Do you have a multimeter handy? Try measuring for the battery output voltage where the batteries connect to the board. It's possible the corrosion on the terminals broke that connection.

Try using a bit of dilute vinegar or citric acid on the areas that were corroded. Scrub the affected areas with a toothbrush until any bubbling you might see stops, and then rinse it with clean water. Any corrosion left over from your initial cleaning could spread, and even a thin layer can interfere with the batteries making good contact.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod