Hello, today is my first time using programmer since I didn't need it before.
First I run software and it ask for firmware update and update complete successfully
After that I could never read SOP8 eeprom and tried a few dip and smd 25 series
I ran the self test and it says ERROR
Voltages shows 4.87V, 1.67V, 1.64V and 9.28V at one point it showed normal but 3.3V was somewhere in 2V and other voltages looked good
Its now never reached normal and so far haven't programmed a single device yet...
On first check it gives red text there after just x or dashes
What is the solution to this or did my programmer arrive defective?
It also show firmware update greyed on GUI but i don't think necessary anymore since it was done before?
Got it from seller on AliExpress:
https://www.aliexpress.com/store/4805043 so I'm sure its a reputable seller?
Thank you for any help you can give me