EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: atgeek on April 27, 2017, 07:54:40 am

Title: Xl830l multimeter repair
Post by: atgeek on April 27, 2017, 07:54:40 am

I made a mistake by passing more than 200mA in this multimeter, it seem a resistor is blown. Anyone with the same multimeter could give the resistor value? Thanks

Title: Re: Xl830l multimeter repair
Post by: carl_lab on April 27, 2017, 08:35:46 am

Do you mean the 1R00 resistor (1 \$\Omega\$)?

No fuse inside? You should add a fuse (200mA fast) or dump this "quality gear"...

Title: Re: Xl830l multimeter repair
Post by: atgeek on April 27, 2017, 08:55:44 am

No, I mean the resistor near the 1Ohm one, a fuse is still present but it doesn't blown :D maybe because it's too cheap