« previous next »
Pages: [1]   Go Down

Author Topic: Yaesu FT 101 pre-repair checkout  (Read 1651 times)

0 Members and 1 Guest are viewing this topic.

Offline ShockTopic starter

  • Super Contributor
  • ***
  • Posts: 4217
  • Country: au
Yaesu FT 101 pre-repair checkout
« on: July 09, 2016, 03:35:22 am »
Good video showing pre-repair checkout of a modular radio.
Covers checking out supply rails before powering up, relay cleaning and a few common issues of aging equipment.

Logged
Soldering/Rework: Pace ADS200, Pace MBT350
Multimeters: Fluke 189, 87V, 117, 112   >>> WANTED STUFF <<<
Oszilloskopen: Lecroy 9314, Phillips PM3065, Tektronix 2215a, 314
 

Offline Towger

  • Super Contributor
  • ***
  • Posts: 1645
  • Country: ie
Re: Yaesu FT 101 pre-repair checkout
« Reply #1 on: July 09, 2016, 07:52:59 am »
I am not sure if I missed a bit, but I take it the origional audio board with the bad caps was replaced with an older version.  Looks as if the rig was used as a donor, never a good sign.
Logged
 

Offline Len

  • Frequent Contributor
  • **
  • Posts: 547
  • Country: ca
Re: Yaesu FT 101 pre-repair checkout
« Reply #2 on: July 09, 2016, 02:16:36 pm »
Logged
DIY Eurorack Synth: https://lenp.net/synth/
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee