Electronics > Repair

Yes, I bought another Keithley (196) to repair (FIXED!)

<< < (8/8)

So, all fixed.

I dropped a polypropylene cap in (https://www.eevblog.com/forum/buysellwanted/wtb-couple-small-value-polystyrene-caps/) in place of the polystyrene 68pF that was bad, and it both fit perfectly, and I would guess should behave very close to the PS cap.

Calibration seems very close, but I don't have a meter that makes a good transfer "standard"... it just compares well to my Keithley 199 that I had previously "calibrated" to my bench power supply. At some point, I'll send one of them off for calibration.

Thanks for the input all!


[0] Message Index

[*] Previous page

There was an error while thanking
Go to full version