[DIY] TS100 + T12 OLED Dual/Quad Soldering Station

[sn4k3]

If you are like me that like multiple tools to work or try, nothing better than save space, organize and keep things easy and lightweight.






Features:

• Dual output (TS100 + T12 STM32 2.1S OLED)
• Quad output (4xTS100)
• Seven output (7xTS100)
• Seven output, cut as you go (NxTS100)
• Support two power supply models (6A or 9A)
• Independent Switchs for every output including mains
• Voltage and current metter for a pleasant view and LiPo voltage control
• DC jack for external power supply, eg: LiPo
• Bottom vent holes + rubber pad slot
• Can change front and back plates easy to convert into other station without reprint main body
• Stackable!

BOM:

• 1 x AC/DC 24V power supply
  https://www.banggood.com/4A-To-6A-24V-Switching-Power-Supply-Board-AC-DC-Power-Module-p-969204.html
  https://www.banggood.com/AC-DC-Switching-Power-Supply-Module-AC-100-240V-to-DC-24V-9A-Power-Supply-Board-p-1086527.html
• 1 x round switch for mains
• 2 x mini rectangular switch
• 1 x digital ammeter
• 1 x GX12 RS765 aviation plug with 2 or 3 pins for TS100
• 1 x T12 STM32 2.1S OLED
• 1 x TS100
• 1 x 2 core silicone cable and DC jack for TS100 DYI cable
• Cable for wiring
• 4 x M3 8mm Self trap screws for psu
• 4 x M3 galvanic square nut
• 4 x M3 machined screw

Soon i will be able to sell the the whole system, if anyone interested and too lazy to DYI 
I will also publish 1 output TS100 and 2 output TS100 versions / plates, but there are space for 7 x TS100 outputs

More info here: https://www.thingiverse.com/thing:2847365
And photo album here: https://www.facebook.com/pg/PTRTECH/photos/?tab=album&album_id=362067290944117

[Bratster]

That's pretty cool, good job!

[sn4k3]

That's pretty cool, good job!

Thank you! This project also aim teams who need more irons and less confusion and mess.
Up to 7 TS100! Overkill but i have space