Products > Other Equipment & Products

Aixun T3A misbehaving on grounded PCBs

<< < (13/16) > >>

hasbihal:
@Tony did you try plugging in a 3.5mm jack for ESD? I just read somewhere else that an old system used to have grounded tips but as soon as plugging in even a blank 3.5mm jack into the ESD jack, the tip was not grounded anymore. Try that

tony359:
on the T3A?

The T3A has a banana jack at the back, not a 3.5mm jack. I'm not sure I'm following.

I've been thinking of cutting the ground of my traditional solder iron to avoid the issue but I don't think it's a good idea. It could be dangerous for the PCB I reckon?

run_rabbit:
A new version is up, have you tested it?

https://aixun-updates.github.io/#t3a

Icchan:
Plot thickens... I believe floobys solution would fix all of this: https://www.youtube.com/shorts/6rK7ACrbukI
Because it all makes sense.

floobydust:
OMG AiXun T3 tip has enough PWM noise enough to make a speaker buzz?!  :palm:
Too cheap china, too cheap on the cable, or maybe they wired the handle wrong.

It would take 1 minute with a scope to figure out this drama.

Navigation

[0] Message Index

[#] Next page

[*] Previous page