Products > Other Equipment & Products

Hot air station HES-1000 ST from STAHLWERK

<< < (9/9)

jackobo:

--- Quote from: tooki on June 20, 2023, 06:36:31 pm ---What makes you think the temperature reaching the board is anywhere near that stable?!? Just moving a cm closer or farther is going to make a massive difference in actual temperature at the board. Precise temperature control (like a soldering iron) is pointless in a handheld hot air device.

--- End quote ---
From working with the hot air station))) Got old 858d+ one, well calibrated,normal working distance from the board up to 10mm. And if you station overshoots say 30-40 celcius you can simply screw the board traces up. Normally -+ few mms gives -+ a few degree fluctuations.

Navigation

[0] Message Index

[*] Previous page