Products > Other Equipment & Products

KSGER T12 STM32 V3.1S soldering station

<< < (19/19)

eevnoob:
hi, has anyone taken a look at this new variant of the KGSER T12, with "STC Controller V2.3"? it's marketed as having a grounded chassis and a (new?) display. would there be any disadvantage to using a non-stm32 controller?
https://www.aliexpress.us/item/3256804499899529.html

ygi:
If you're just going to use it as it is, µcontroller doesn't matter as it doesn't take much performance to drive a soldering station. It's when you want to use a custom firmware that you need to mind it for compatibility.
Basically, it makes more sens for Chinese manufacturers to spend money in a bigger screen than in a reputable ST branded chip.

DavidAlfa:
Why is the earything so critical? Takes two minutes to earth any other station.

Navigation

[0] Message Index

[*] Previous page