| Products > Other Equipment & Products |
| Miniware MHP50 |
| << < (12/13) > >> |
| shabaz:
I wonder if the MHP50 has enough power to work as a solder bath/pot. That would be a nice attachment if it existed! I need to purchase a small solder bath/pot, and I'm going to use it so rarely that I don't want to spend a lot, but, at the same time, I don't want to buy something bottom-end that might not be safe. |
| bdeianov:
If you use the reflow profile feature, I recommend NOT upgrading to the 2.00 firmware. While the temperature ranges have been relaxed, the reflow settings don't actually appear to work. The rise and keep times are not respected and regardless of what I set WeldTemp to, the maximum temperature always seems to go to 230 C. On top of that, downgrading to 1.01 doesn't currently seem possible. You can install it, but the UI is messed up. Avoid for now... |
| orzel:
--- Quote from: bdeianov on December 11, 2024, 02:25:45 am ---If you use the reflow profile feature, I recommend NOT upgrading to the 2.00 firmware. While the temperature ranges have been relaxed, the reflow settings don't actually appear to work. The rise and keep times are not respected and regardless of what I set WeldTemp to, the maximum temperature always seems to go to 230 C. On top of that, downgrading to 1.01 doesn't currently seem possible. You can install it, but the UI is messed up. --- End quote --- Ouch ? I was about to do the update... :phew: Anyone else with such an experience ? |
| bdeianov:
--- Quote from: bdeianov on December 11, 2024, 02:25:45 am ---On top of that, downgrading to 1.01 doesn't currently seem possible. You can install it, but the UI is messed up. --- End quote --- Update: Miniware have added the UI file to their 1.01 firmware download, so it's now possible to downgrade back to 1.01. :phew: |
| Cyclotron:
I was about to go to 2.0 as well. I'm very impressed with this little thing. It will be very handy. |
| Navigation |
| Message Index |
| Next page |
| Previous page |