Products > Other Equipment & Products

Question about Hakko FH200-01 iron holder (or similar)

(1/1)

M-Reimer:
Hello,

can someone who owns this holder https://hakkousa.com/fh200-01-fm-2027-fm-2030-iron-holder-w-599b-tip-cleaner.html please measure the inner diameter of the section where the iron goes in? Preferrably in metric units (millimeters).

It has to be this legit Hakko holder and not the similar looking item from China. The chinese one has different measurements!

I plan to use this holder with a different iron that I already own but want to know if my iron actually fits into there before I order the iron stand.

Thank you very much in advance

Edit: Just to be more precise: I need the inner diameter of the section the iron slides into and not the smaller inner diameter of the end stop which stops the iron from falling through :P

thm_w:
19.3mm at the entry, 19.0mm before the end stop, there is a slight taper.
The mating part of the handle is 18.55mm

Navigation

[0] Message Index