Products > Other Equipment & Products

CFW for KSGER/Quicko STM32 Soldering Stations

<< < (478/596) > >>

ricktendo:

--- Quote from: DavidAlfa on November 30, 2021, 11:13:23 am ---Is anyone running the latest fw in a Ksger v2.1 board?

--- End quote ---

Hello David, tested on this 2.1 board revision and I can confirm NO issues with the latest firmware.

ygi:

--- Quote from: wickated on November 30, 2021, 11:01:16 am ---
--- Quote from: DavidAlfa on November 30, 2021, 07:13:19 am ---I guess a 4-pin connector joins earth and gnd, like this:
- Power
- NTC
- Shake
- Ground from power supply
+ chassis earth

--- End quote ---
this

--- End quote ---

Yep, I just finished rewiring the handle and that's what I have (that's why I asked in the first place). Anyway, the Handskit 5 pins handle turned out to be a 4 wires cable with a 5 pins connector so there isn't even a NTC inside to worry about. :-//

Thanks for your input guys.

DavidAlfa:
Thanks, Rick :-+
TeamTeacup, can you make pictures of your board, specially showing the stm32 in it?

TeamTeacup:
Here's both a full shot of the board, and a closeup of the STM32. I did my best with contrast to make it as easy to read as possible.

DavidAlfa:
Hmm everything looks correct.
Have you tried downloading the file again just in case?

Navigation

[0] Message Index

[#] Next page

[*] Previous page