Products > Other Equipment & Products
CFW for KSGER/Quicko STM32 Soldering Stations
DavidAlfa:
This is the C245 connection
moffet:
--- Quote from: Tugo on January 06, 2022, 12:44:34 pm ---Everything understandable?
--- End quote ---
Understood.
I guess I have to also replace original 75W power supply with something bigger, like this one:
https://allegro.pl/oferta/zasilacz-impulsowy-24v-240w-10a-cnc-led-reprap-11019179682
Tugo:
--- Quote from: moffet on January 06, 2022, 04:14:53 pm ---I guess I have to also replace original 75W power supply with something bigger, like this one:
https://allegro.pl/oferta/zasilacz-impulsowy-24v-240w-10a-cnc-led-reprap-11019179682
--- End quote ---
I don't think you need it. At least you don't need it from the start. You can use your current PSU. You just have to go into settings and limit power.
David, am I wrong about this?
DavidAlfa:
Meh, the cheap 75W rarely handles that, usually it resets or greatly reduces the voltage.
Try it, if it goes bad then get a better PSU.
DavidAlfa:
There's a new model, the T12-959, with 2.6" LCD.
It seems to use stm32 but I didn't find any board pictures.
https://a.aliexpress.com/_msv7R9K
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version