Products > Other Equipment & Products

CFW for KSGER/Quicko STM32 Soldering Stations

<< < (661/672) > >>

DavidAlfa:
I won't anytime soon neither in my planning at all, I have a life!

ygi:
I'm sure I can find enough junk with trash tier firmwares on aliexpress to keep you busy for your next 10000 lives >:D

DavidAlfa:
I haven't powered the computer for at least 15 days now..., too busy ;)

czullo:

--- Quote from: zhir on February 03, 2023, 12:54:51 pm ---On a side note, as I was browsing around, I noticed that the same company also sells a similar-looking unit but with a heatgun. And guess what? It´s an STM32 too!  :clap:
David, hot air stations need a better firmware as well !  You could start a new project!
These units are cheap. Think about it.

--- End quote ---

To bad its FAKE STM32 ;)

yelkvi:
David, I have a problem with the LCD display. When turned on, the display works normally. And when the soldering iron handle is on the stand and the soldering station is in Stand By mode, then artevacs appear on the screen, as in the photo. It may even be a completely black screen.
The only way out of this mode is to restart the soldering station.
Latest firmware: January 2023. Firmware from May 2022 - also.

Navigation

[0] Message Index

[#] Next page

[*] Previous page