Products > Other Equipment & Products

CFW for KSGER/Quicko STM32 Soldering Stations

<< < (726/801) > >>

Wsander12:
My question is this. Is the hakko t9 tip for the hakko fm2023. The same as the t12. Meaning could you use one t9 tip on these hakko clones. I could get my tweezers to work on two units one unit for each side of the tweezers. But my concern would be would the t9 tip work the same as the t12. Is there any difference between the tips other then size and dimensions. I don't mind running two stations for each tip. As long as it's compatible.

DavidAlfa:

--- Quote from: anwfeb on August 03, 2023, 09:36:05 am ---I did the calibration, and the measurement calibration results are (...)

--- End quote ---
I did this on mine (T12 tips)
Setpoint / measured
200 212
250 250
300 299
350 356
400 398
450 444

As you see, adding more calibration steps would be pretty much useless.

Can anyone using JBC tips perform this test?
And if you used AliExpress JBC knockoffs before, kindly explain to anwfeb how terrible they are compared to genuine tips!

wickated:

--- Quote from: DavidAlfa on August 17, 2023, 06:23:22 pm ---
--- Quote from: anwfeb on August 03, 2023, 09:36:05 am ---I did the calibration, and the measurement calibration results are (...)

--- End quote ---
I did this on mine (T12 tips)
Setpoint / measured
200 212
250 250
300 299
350 356
400 398
450 444

As you see, adding more calibration steps would be pretty much useless.

Can anyone using JBC tips perform this test?
And if you used AliExpress JBC knockoffs before, kindly explain to anwfeb how terrible they are compared to genuine tips!



--- End quote ---
those are some new type of calibration? (im still on 21y build)

knockoffs jbc get +100-150 C on same adc settings as genuine

DavidAlfa:
No... Same as always.

Chaoticoz:
Hi, I just received the KSGER T12 3.1s.

The chip is not STM32 but MM32SPIN, how bad is this?

Also I noticed the tip isn’t grounded, I think there might be a connection missing from PE on the power supply to PE on the control board?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod