Products > Other Equipment & Products

CFW for KSGER/Quicko STM32 Soldering Stations

<< < (868/874) > >>

ascarons22:
It works, I measured those tips out of curiosity and they are all above 17 ohms. I will not buy from that store again. Thanks.

Zamagen:
Hello,
I have a KSGER V2.1S board, very similar to the one pictured on github:



It's currently wired to a T12 Handle, but I bought a C245 handle and would like to use it.
I've browsed all the pages of this thread, but I'm Very confused about how should I wire it...

Some posts mention a jumper/resistor to be removed, does this PCB need the modification?
Where is the Jumper? And I've also read that instead of removing the Jumper a 1MOhm resistor should be inserted, is it correct?
 
And how should I wire the handle?
There are 3 wires: Green,Blue and RED (going from the tip to the tail of the cartridge),
Are these GND, Sensor and +Voltage (the T12 uses these colors) or GND, +Voltage and Sensor?

DavidAlfa:
Not very straightforward in this board!

moffet:
The message
    putStrAligned("New/low batt?", 0, align_center);
    putStrAligned("Forgot last", 16, align_center);
    putStrAligned("used settings.", 32, align_center);
    putStrAligned("Restored dflt.", 48, align_left);

doesn't respect display flip X/Y settings.

DavidAlfa:
That's because it's a failsafe message before the settings are loaded.

Navigation

[0] Message Index

[#] Next page

[*] Previous page