EEVblog Electronics Community Forum
Products => Other Equipment & Products => Topic started by: sonnytiger on January 07, 2014, 12:18:20 pm
-
TB6600 Stepper Motor Driver Board (https://www.youtube.com/watch?v=JjbCv3EOp7M#ws)
Just a kind of review I guess.
Thought you guys might want to know about this driver board. It's not terrible quality, works quite well and isn't too expensive.
My experience is limited with these driver boards so if anyone could tell me what they think of this driver board compared to what they have seen.
Don't worry, I know it isn't revolutionary or anything.
-
hi,
i saw your video on youtube and i'm interested in your driver code coz i have the same set up but it seems that i have low knowledge of arduino programming! :(
i cant work it out to run my motor smooth like you do .
so, please can you help me and maybe send me trough e-mail your .ino files for driver and motor ?
thx
-
Thanks for the video.
I googled that controller, and found the original non-ebay source:
http://www.hotmcu.com/tb6600-1-axis-stepper-motor-2phase-driver-board-for-cnc-router-p-56.html?cPath=7_30 (http://www.hotmcu.com/tb6600-1-axis-stepper-motor-2phase-driver-board-for-cnc-router-p-56.html?cPath=7_30)
TB6600 1 axis Stepper Motor 2-phase Driver Board for CNC Router
US $16.00
China prices, always amazing. Another thing now on my 'to buy' list.
Kind of a pity the drive current isn't software programmable, so it could be beefed up during acceleration and high torque, then dropped back to a low level for position holding.
You didn't get any schematic with it?