Author Topic: Weller Piston O-Ring  (Read 593 times)

0 Members and 1 Guest are viewing this topic.

Offline 2XTopic starter

  • Frequent Contributor
  • **
  • Posts: 268
  • Country: gr
Weller Piston O-Ring
« on: April 23, 2024, 09:37:53 pm »
I have the Weller SA21A desoldering pump and I his vacuum isn't so power anymore. I bought a new one but I would like to repair and my old one. I measured the O-ring from the piston and the dimensions are below. Do you know if these O-rings are made from some certain material or they are just a regular O-ring? I didn't find any official replacement form Weller. The only spare that I found is the desoldering tip (Part Number: SA21A1).

Inner Diameter: 13,5mm
Outside Diameter: 18,1mm
Thickness: 2,5mm


Offline PeterG

  • Frequent Contributor
  • **
  • Posts: 833
  • Country: au
Re: Weller Piston O-Ring
« Reply #1 on: April 23, 2024, 10:39:46 pm »

That size appears to be a standard size o-ring.

You can source them from places such as this.
Testing one two three...
The following users thanked this post: 2X

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo