Electronics > RF, Microwave, Ham Radio

ADF4360-0 cannot lock

<< < (5/5)

WOWOWOWOWO:
The frequency sweep problem has been solved. It turns out that the data I sent is wrong, but my power is very low. I don't know how to increase it. Is my PCB trace not matched to 50 ohms? And when I use 0.1s as the frequency sweep step time, the measurement occasionally produces a little noise. I do not know how to solve this. |O

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version