Electronics > RF, Microwave, Ham Radio

cable brand and type for lab BNC cables 50 ohm?

<< < (6/6)

coppercone2:
https://www.shireeninc.com/osc/rg316ds-by-the-ft

coppercone2:
4 of the cables turned out to have short circuits, I thought I assembled them perfectly. what a bastard

should just have bought this shit, at this rate I will be not saving any money

when you make it hook it up to a function generator at high speed then wiggle the cable around looking at the scope to see if it fucks up

coppercone2:
I think a strand of shield got under the dielectric tear because some cuts were not performed well. Teflon has a plastic bag effect (it kinds of like dough and deforms) I recommend an illuminating magnifier because if this happens then you won't see the reflection twirling it under a light easily

Hamelec:
a lot of data will be found here:
https://www.kabelwissen.de/koaxialkabel/bildergalerie/
for flexibility look into the datasheet "Min. bending radius"..

coppercone2:
that looks like a great website

Navigation

[0] Message Index

[*] Previous page