Electronics > RF, Microwave, Ham Radio

First RF PCB Design

<< < (4/4)

Thanks for the suggestion.

Please do comment on this PCB layout which I have revised.

I have designed it for 0.6mm thickness PCB with 1.2mm track width. This track width is much wider and may cause clearance issues with other pads. I used another pad and aligned with components' pads so track keeps some clearance.

Bottom layer is solid ground and this is unfinished board.



[0] Message Index

[*] Previous page

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod