Electronics > RF, Microwave, Ham Radio
How to use `nickel powder` and `lime powder` to paint `faraday cage`?
youta556:
I try to build `faraday cage` room for RF testing,this job is for shield low frequency RF radiation.
I mix nickel powder,316 stanless steel powder and lime powder,add some water,that's my material of painting.
Before I start painting,I ask for advices here.Any formula of ingredients?Is that enough paint only one time?What will happen if I leave floor unpainted?Anything I should notice based on your experience?
ahbushnell:
What frequencies?
youta556:
frequency band is 10hz-10Mhz.
ahbushnell:
What do you want to shield against? Electric fields or magnetic?
youta556:
Electric fields.
Navigation
[0] Message Index
[#] Next page
Go to full version