Just receive this device for one project and already configure it for the purpose.
But to perform all this measurements manually can cause additional mistakes .
Due to this I would like to automate this process .
I already connect to device via telnet using 5024 .
But when I saw this manual (
http://anlage.umd.edu/Microwave%20Measurements%20for%20Personal%20Web%20Site/E5062A_Programmers_Guide_E5061-90042.pdf)
looks like it will take more time that I have .
Maybe anyone have some example of code how to initialize this device via telnet ?
Is it posible to setup device manually and only get value from the markers ?
I found this command :CALC{1-4}:MARK{1-10} - but device ignore it and only beeping with error

.
Thanks in advance .