Author Topic: Searching for a simple way to use AS-interface  (Read 141 times)

0 Members and 1 Guest are viewing this topic.

Offline printplaatreparatie.nl

  • Contributor
  • Posts: 11
  • Country: nl
Searching for a simple way to use AS-interface
« on: March 26, 2020, 06:22:57 pm »
Hi there, I got hold of some Eaton Rapid Link 4.0 Frequency controllers and motor starters. I would like to use them in a to-be-determined project, but I have no idea how to use the AS-interface in a simple way, without spending a lot of money and leaning to program a PLC.

I found this raspberry pi board: https://tinyurl.com/tv4g356 but found no information how to use it.

Ideally, I would like to use an (industrial) Arduino or simular open-source device to get those units to behave.

Can anyone shine some light over the black box of AS-interface? All I can find is how amazing it is (for machine builders with a nice budget.)
 

Offline rvalente

  • Frequent Contributor
  • **
  • Posts: 317
  • Country: br
Re: Searching for a simple way to use AS-interface
« Reply #1 on: March 29, 2020, 04:12:20 pm »
Do you really have to use ASI?

For me, was a network that although has been used, never saw much of a commercial success nor interest to be maintained by users.

If you wanna learn about ASI try to find some used modbus 485/ethernet to asi interfaces.

If you can get away without it, do, go for modbus or canopen
 
The following users thanked this post: printplaatreparatie.nl


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf