EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: jusaca on July 05, 2017, 08:50:02 am

Title: [Keysight 1000x] Disable cursor during measurement
Post by: jusaca on July 05, 2017, 08:50:02 am

Is there any way to disable the cursors, when you have some active measurement? The manual says that cursors are activated during measurement to show the part of the signal which is used for the measurement. This can be helpful, but most times I think they are more annyoing  :-\
It must be possible to hide them?

Hope somebody knows the answer
jusaca

Title: Re: [Keysight 1000x] Disable cursor during measurement
Post by: jusaca on July 18, 2017, 01:08:19 pm

Just if someone else is interessted:
Keysight support told me, that there is no way to disable cursors with activ measurements ;(

Maybe with a new firmware?