Products > Test Equipment
0,2V Offset on DC Measurements with Picotest M3511A DMM
<< < (4/4)
MaxH:

--- Quote from: MaxH on May 26, 2021, 11:07:54 am ---Apparently I measured the .2V from the OP Input against the "DMM Input GND" and to the test-pin, between the Input pins of the OP I have have 0V

I looked closer at the Input-Section or the "Input GND" path and there is Q209 which has the .2V Offset. If the "DMM + Input" is left floating I dont see those .2V  (blue badly drawn line)

--- End quote ---

Late Update: The problem got mostly fixed by replacingh Q209, I also replaced U202 but Im not sure anymore if that was optional.
I seem to get correct measurements now but a slight offset when measuring open leads, I couldnt trace that back yet. Maybe its a wrong transistor type, I used a BC850
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod