Products > Test Equipment

100:1 probe for measuring ripple in a tube amp power supply

<< < (16/16)

David Hess:
High voltage x100 probes with 10 to 50 megohm input resistance indicating a shunt resistabance to attenuate the DC voltage still exist, at least in theory, but they cost almost $1000 now.  I think Testec used to have a lower cost one but apparently no more.

vk6zgo:
The only time I've needed a x100 probe was as a "cheap & nasty" substitute for an active probe, back when such devices were prohibitively costly.
They were, of course, conventional ones, but the signal I was looking at required a device with around 100 M input impedance, & was of fairly high level, so it was (just) adequate.

tautech:

--- Quote from: vk6zgo on December 21, 2022, 11:29:41 pm ---The only time I've needed a x100 probe was as a "cheap & nasty" substitute for an active probe, back when such devices were prohibitively costly.
They were, of course, conventional ones, but the signal I was looking at required a device with around 100 M input impedance, & was of fairly high level, so it was (just) adequate.

--- End quote ---
Yes, an often overlooked advantage of the 100x probe is the low input capacitance, often well under 5pf.

floobydust:
This looked reasonable, without the danger of AC-coupling being a problem.

David Hess:
That is basically the P6009 schematic, shown below.  It takes a little more than the bare essentially to get 100+ MHz performance.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod