Products > Test Equipment
121GW strange range/socket problem
Morg:
--- Quote from: J-R on August 26, 2024, 06:25:48 am ---If flexing the jack a certain way solves the issue, then just keep doing that while you hunt?
--- End quote ---
While hunting, the DMM is off, so I can't "hunt" for real, just try to find non-connections where connections should be. I couldn't find any so far...? So flexing couldn't make it better... I am a bit confused about this.
--- Quote ---Also, it looks like the sense connection for the mA/uA jack goes into an inner layer of the PCB then goes under the selector? Does pressing on the selector make any difference?
--- End quote ---
The rotating selector? No, nothing.
Navigation
[0] Message Index
[*] Previous page
Go to full version