Products > Test Equipment
3.5kV power supply teardown
<< < (6/8) > >>
Lodoiska:
Hi!
If you woudn't mind, I would greatly appreciate it!!
Thank you so much.

Safe travels,
Lodo
Diplomata:
Hello

Do you know who the manufacturer of the power supply enclosure is?
Or does anyone know who is the manufacturer of Pharmacia AKTA system housings?
I can only realize that they are made of cast aluminum / magnesium ...
And it should be a northern European manufacturer, since it was of Swedish construction. Thank you.

Best regards

Carlos Barata
coromonadalix:
They are beautiful :)  drool
klim:
Hi, could you please upload a picture from your plug connectors for this device, i'll get mine next week, but also without any connection plugs, so i need to make my own.
HighVoltage:
Just saw your post now...

First I used self constructed 2mm connectors.
But at the end I did not like them too much.
Then I rebuilt the connector completely for 4mm banana plugs

For up to 1000 Volts I am using the MC insulated cables.
For 1000 to 3500 Volts I am using my self made 20.000 Volts cables to 4 mm banana plugs.

Here are some pictures of my setup.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod