| Products > Test Equipment |
| 3D Printable VESA mount for DHO800/DHO900 Scopes |
| << < (3/3) |
| jsobell:
Yes, the slicer (I use OrcaSlicer) lets you preview the slices, then you can add a 'pause' at the lever you want to insert the magnet. I think most of them support this and it's just a case of working out where the option is :) You do have to glue the magnets in when you do this, otherwise they tend to stick onto the extruder head as it passes over. I would also suggest only adding 0.4mm (two layers) of plastic over the top, as any more than that and the magnet's attraction is reduced a lot. Oh, and don't forget, make sure it's not adding supports in where the magnets go ;D |
| Navigation |
| Message Index |
| Previous page |