Products > Test Equipment

3D Printable VESA mount for DHO800/DHO900 Scopes

<< < (3/3)

jsobell:
Yes, the slicer (I use OrcaSlicer) lets you preview the slices, then you can add a 'pause' at the lever you want to insert the magnet.
I think most of them support this and it's just a case of working out where the option is :)
You do have to glue the magnets in when you do this, otherwise they tend to stick onto the extruder head as it passes over.
I would also suggest only adding 0.4mm (two layers) of plastic over the top, as any more than that and the magnet's attraction is reduced a lot.
Oh, and don't forget, make sure it's not adding supports in where the magnets go ;D

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod