Products > Test Equipment
4 channel Keysight 1000x series scope
TheSteve:
Firmware for the DSOX1204x series is now posted on the Keysight website. As this scope runs linux it should be interesting to take a peak at.
Version 2.01
https://www.keysight.com/main/software.jspx?ckey=3023906&id=3023906&nid=-32110.1258590&lc=eng&cc=US
Release notes:
Enhancements
- The following Frequency Response Analysis (FRA) enhancements were added:
o The sweep frequency range is no longer limited to decade values – it can now be
set to any frequency within the WaveGen’s limits.
o The “points per decade” setting has been changed to “total points” for ease of use.
o FRA Chart:
Minor gridlines for the horizontal axis are now shown to improve readiblity
of the plot.
The chart’s horizontal display range is now independent of the Start/Stop
Frequency setting in the Setup Menu.
- Boot-up time was reduced.
- Improved the color constrast for Channel 3 and Channel 4’s waveform persistence.
- Miscellaneous LAN enhancements.
Bug Fixes
- Fixed missing “Time Reference” softkey.
- Fixed an unused softkey briefly appearing in the Pattern Trigger menu.
- Fixed an issue of the inverted channel mode not displaying the waveform correctly in
Averaging Mode.
mikeselectricstuff:
--- Quote from: TheSteve on March 22, 2019, 08:28:36 am ---- Boot-up time was reduced.
--- End quote ---
Was 58 seconds, now 32 secs
1102G : 21 secs
TK:
I am curious about how much hardware it shares with the 2-channel 1000X scopes... no teardown yet?
Mr. Scram:
--- Quote from: TK on March 22, 2019, 12:58:54 pm ---I am curious about how much hardware it shares with the 2-channel 1000X scopes... no teardown yet?
--- End quote ---
It's been surprisingly quiet.
extide:
Well, Mike has one and he has posted internal pics earlier in this thread. It is based on the same hardware platform as the 1002X series scopes, very similar platform. I don't know if anyone has done a video tera down, though.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version