| Products > Test Equipment |
| 4 channel Keysight 1000x series scope |
| << < (11/26) > >> |
| mikeselectricstuff:
--- Quote from: nctnico on December 29, 2018, 02:27:06 pm ---Great :-+ Any datasheet? I'm very curious to see whether Keysight has come up with something radically new which can stand up against the cheaper Chinese scopes or it is just meh. Either way it is interesting Keysight went for a shared controls. --- End quote --- No time to look atm - they've done it similar to R&S, RGB LED to indicate which channel the vertical controls control |
| TK:
If it is based on the same hardware / software as the 2 channel 1000X series, then I don't expect many changes except for the 1.5 additional channels (4 channel VS 2.5 channel) The good news will be that the 1000X 2 channel software was hacked by one of the EEVBLOG forum members, so I assume the same hack technique can be applied to the new scope Probably Keysight will release a single firmware for both 2 and 4 channel scopes on the 1000X series, like what they do with 2000X and 3000X |
| ci11:
--- Quote from: mikeselectricstuff on December 29, 2018, 02:36:10 pm --- --- Quote from: nctnico on December 29, 2018, 02:27:06 pm ---Great :-+ Any datasheet? I'm very curious to see whether Keysight has come up with something radically new which can stand up against the cheaper Chinese scopes or it is just meh. Either way it is interesting Keysight went for a shared controls. --- End quote --- No time to look atm - they've done it similar to R&S, RGB LED to indicate which channel the vertical controls control --- End quote --- Looks pretty but seeing that KS went to the trouble of magnifying the 1mV/DIV to 500µV/DIV, I wonder what the actual noise performance is? Over the past year, I found the LeCroy HDO, R&S RTB / RTC / RTE / RTM all hover between 50µVrms and 100µVrms on actual testing with BWL on. Much to my surprise, none matched the SDS1104X-E at under 30µVrms despite all "Low Noise" claims in all their brochures. When you have time, perhaps you can post µVrms and µVpp readings with BWL off and BWL on? Screenshots be great too! Thanks. |
| Carrington:
--- Quote from: nctnico on December 29, 2018, 02:27:06 pm ---... I'm very curious to see whether Keysight has come up with something radically new (with more memory) which can stand up against the cheaper Chinese scopes or it is just meh. --- End quote --- Just 1Mpts! |
| nctnico:
--- Quote from: Carrington on December 29, 2018, 03:58:17 pm --- --- Quote from: nctnico on December 29, 2018, 02:27:06 pm ---... I'm very curious to see whether Keysight has come up with something radically new (with more memory) which can stand up against the cheaper Chinese scopes or it is just meh. --- End quote --- Just 1Mpts! --- End quote --- Which turns into 250kpts in a regular usage scenario with all channels on. I was hoping Keysight would finally see the light but I guess they are not. :'( IMHO Keysight makes great oscilloscopes but the memory is just too small. |
| Navigation |
| Message Index |
| Next page |
| Previous page |