Author Topic: FeelTech FY6600 Software Interface  (Read 219 times)

0 Members and 1 Guest are viewing this topic.

Offline SteveJH

  • Newbie
  • Posts: 3
  • Country: gb
FeelTech FY6600 Software Interface
« on: February 16, 2020, 04:46:43 pm »
I have just purchased a FeelTech FY6600 AWG to do some automated testing. My intention was to write a LabView interface so that I can remotely control the FY6600. I have previously written a lot of these interfaces and rarely have a problem getting them to connect. Not so with the FY6600. I know that the driver is working OK as the FY6600 PC software connects and runs. However, entering the commands from RealTerm, Termite or LabView does not get any data back from the unit. I have even used Device Monitoring Studio to sniff the data packets sent by the FY6600 PC Software during startup and normal operation and all the data bytes look sensible according to the documentation. I have tried all the usual things such as different Baud rates, stop bits etc with no luck. Has anyone been able to get the USB interface to work apart from with the stock PC software? Regards Steve
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf