Products > Test Equipment

A look at the Uni-T UT210E

<< < (100/177) > >>

lavardera:

--- Quote from: perieanuo on March 05, 2018, 07:29:51 am ---99%

Envoyé de mon HUAWEI NXT-L29 en utilisant Tapatalk
--- End quote ---

99% what? 99% alike? Do you have the ExTech, have you opened it up?

perieanuo:
You got your answer. You asked what is the probability bla bla bla, I said 99.what's unclear? Rebranding sounds familiar to you? Same shape, same LCD, same switch. No need to be aggressive if you don't know, put questions on the table without even putting together q and a.

Envoyé de mon HUAWEI NXT-L29 en utilisant Tapatalk

lavardera:
Sorry - you are misreading. No aggression intended. Just hoping there was more substance to your reply, but you don’t own one.

Interesting - I read elsewhere that ExTech had a recall on these models due to loose screws on a terminal contact. Found this on their site.  http://www.extech.com/display/?id=16536

macboy:

--- Quote from: perieanuo on March 06, 2018, 07:29:30 am ---You got your answer. You asked what is the probability bla bla bla, I said 99.what's unclear? Rebranding sounds familiar to you? Same shape, same LCD, same switch. No need to be aggressive if you don't know, put questions on the table without even putting together q and a.

Envoyé de mon HUAWEI NXT-L29 en utilisant Tapatalk

--- End quote ---
It is not the same. Look more carefully. The Extech has a 600 mA range for AC only (0.1 mA resolution) plus AC/DC 6 A and 60 A ranges.  The Uni-T has AC/DC 2 A (6 A with mods), 20 A (60 A with mods) and 100 A ranges.

lavardera:
Correct - the Amp ranges are different between the MA63 and the UT210E. But the Amp ranges are also different between the UT210E and the UT210D. I believe somebody posting here has opened the two Uni-T models and said the boards were slightly different. So I'm curious how different the ExTechs are inside.

Here is something - if you look closely at the image at the bottom of the link above there is a picture of the back of the ExTech MA63. There is a sticker there that has an ETL seal and a Certification number. That would mean the meter was independently tested and the rating certified. The UT210E definitely does not have that. The one I bought does not, and I've not seen a certification affixed to any of the units posted here. Somebody would have spoken to that if it existed.

So I think that could spell out significant differences inside the units? I mean what would be needed to actually achieve the ratings posted? Some bus fuses? Or might the board designs be very similar? I can't justify spending the $200 to find out, but I'm curious.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod