Products > Test Equipment

A look at the Uni-T UT210E

<< < (103/177) > >>

Martini:
Yes



...that's the point of the thread.

AudioNoob:

--- Quote from: Martini on March 24, 2018, 03:45:16 pm ---Yes

--- End quote ---
Thanks. Maybe one day I'll learn to use topic search before asking. It seems that it's only doable through firmware update which seems complicated, though. I would have preferred a simple one-wire solder job.
Still reading the relevant posts in reverse chronological order, hopefully there are detailed instructions somewhere.

Martini:
You'll find instructions.

You do have to write in the EEPROM. I'm a bit lazy myself to do it but now that I have two DMM to do, I hope to get it done soon.

AudioNoob:
There is talk of using Arduino for modding the multimeter. Do I understand correctly that you can only read the current configuration with Arduino, but still need a dedicated piece of hardware to flash it back after editing?

Martini:
Can't say I recall that. If that's the case (unlikely, though), that's a bummer.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod