Products > Test Equipment

A look at the Uni-T UT210E

<< < (126/177) > >>

stj:
the patches are for a 210e,
i dont have a datasheet for the chip in yours.
you can still do the backlight mod, but your switch matrix is visibly different.

btw, a 210e dump looks like this:

TheGrave:
While trying to figure out some issues caused by improper measuring technique I went into calibration mode without knowing what I'm doing (not sure on which position the dial was turned)? Got the Err0 message, turned it off. Stupid, stupid, stupid...Could I have screwed something?

Stinger:
Hello !

I looking for modify firmware of UT210E (6000 counts, DC first, order of mode, timer of backlight, APO...).

What is difference between these CH341A programmer ?

https://www.aliexpress.com/item/SOIC8-SOP8-Test-Clip-For-EEPROM-93CXX-25CXX-24CXX-CH341A-24-25-Series-EEPROM-Flash-BIOS/32898599200.html

stj:
no difference, the more expensive option has an extra cable adapter.

jayjr1105:

--- Quote from: Stinger on February 21, 2019, 04:01:53 am ---Hello !

I looking for modify firmware of UT210E (6000 counts, DC first, order of mode, timer of backlight, APO...).

What is difference between these CH341A programmer ?

https://www.aliexpress.com/item/SOIC8-SOP8-Test-Clip-For-EEPROM-93CXX-25CXX-24CXX-CH341A-24-25-Series-EEPROM-Flash-BIOS/32898599200.html

--- End quote ---

Why not just use an arduino?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod