Products > Test Equipment
A look at the Uni-T UT210E
stj:
--- Quote from: jayjr1105 on February 21, 2019, 01:59:06 pm ---
--- Quote from: Stinger on February 21, 2019, 04:01:53 am ---Hello !
I looking for modify firmware of UT210E (6000 counts, DC first, order of mode, timer of backlight, APO...).
What is difference between these CH341A programmer ?
https://www.aliexpress.com/item/SOIC8-SOP8-Test-Clip-For-EEPROM-93CXX-25CXX-24CXX-CH341A-24-25-Series-EEPROM-Flash-BIOS/32898599200.html
--- End quote ---
Why not just use an arduino?
--- End quote ---
because it's an expensive pain in the ass, and you still need to buy an smd socket or clip.
why not use the correct tool for the job??
jayjr1105:
https://www.amazon.com/dp/B016D5KOOC/ref=cm_sw_em_r_mt_dp_U_PxUBCbWE0H20P
$9 is expensive? I just soldered a few 22 gauge solid wires. Took 10 minutes
stj:
$9 is double the cost of the real programmer that also handles 3.3v logic - unlike the arduino.
AND you get the soic clip.
Stinger:
--- Quote from: stj on February 21, 2019, 07:13:12 am ---no difference, the more expensive option has an extra cable adapter.
--- End quote ---
Thank's ! :-+
--- Quote from: stj on February 21, 2019, 02:59:10 pm ---
--- Quote from: jayjr1105 on February 21, 2019, 01:59:06 pm ---
Why not just use an arduino?
--- End quote ---
because it's an expensive pain in the ass, and you still need to buy an smd socket or clip.
why not use the correct tool for the job??
--- End quote ---
Nice Answer ! ;)
I'm neewbie and Arduino necessite time and skills.
------------
Why dotless mod when screen can display dot in good place ?
Deveraux:
I got my meter in the mail today, however, I should really have bought it from a reputable source and not from banggood.
The clamp doesn't work in any range, ac nor dc, so I'm now waiting for a response from customer support. I took a peek inside, to see if there's an obvious fault. Well, the whole row of capacitors along the side of the board is missing. As in, they were never there. ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version