Products > Test Equipment

A look at the Uni-T UT210E

<< < (128/177) > >>

stj:
zero the clamp, i think it only works after you zero it.
that's how DC works anyway.

jayjr1105:

--- Quote from: Deveraux on February 28, 2019, 01:09:18 pm ---I got my meter in the mail today, however, I should really have bought it from a reputable source and not from banggood.

The clamp doesn't work in any range, ac nor dc, so I'm now waiting for a response from customer support. I took a peek inside, to see if there's an obvious fault. Well, the whole row of capacitors along the side of the board is missing. As in, they were never there.  ;D

--- End quote ---

Remember you can only clamp one wire.  If you clamp, say a lamp cord, they cancel each other out and you won't get a reading.  You need an AC line splitter to measure AC wires.  With DC just clamp the red or black wire by itself.

Also, let's see a picture of the inside of yours.  I have a couple hi res photos of mine we can compare. 
--- End quote ---

Deveraux:
D'oh! Don't I feel like an idiot!  ;D Yes, it indeed works with a single strand.  |O
I need to quit jumping to conclusions so often, it's a really bad habit.  :(

The fact that all the capacitors are gone is still quite weird, though. All the pictures I've found have the whole row populated. Attached a photo of my board.

Zeroing is indeed needed. Every time. A bit annoying that.  :-X

jayjr1105:
WTH? that is odd they are all gone.  Maybe someone with more knowledge can explain why 20 some smd caps are missing.

Martin72:
Hi,



Are there any further information ?
What exactly was done to get more bandwith and where the coax output is connected to ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod