Products > Test Equipment
A look at the Uni-T UT210E
Stinger:
--- Quote from: stj on April 21, 2019, 10:03:19 pm ---
--- Quote from: Stinger on April 21, 2019, 09:17:33 pm ---It is possible disable beep sound when changing mode ?
Make μF default range for capacitance ?
--- End quote ---
stop the beep? no.
set the range switch to start with capacitance before resistance/diode - yes.
--- End quote ---
I mean DMM display capacitance measurement only in μF.
stj:
no, you cant disable autoranging without pressing a button.
pratap_369:
My UT210E's current measurement are way off (around 300mA on 20A range and 150mA on 2A range) after I did the calibration (by pressing blue and yellow buttons while turning on the meter) .I did realize that I shouldn't have done that after reading the whole thread :(. Is the calibration is the main reason that gives the inaccurate reading.I did clean the contacts of the selector wheel but the readings are same.
could somebody help me out whats wrong?
here is my eeprom data
Svici:
Just bought an UT210E from UNI-T Official Store on AliExpress, and it come with a missing row of 19 capacitors on PCB.
It works fine as far I can tell, just I am not sure how good is this “new version” of it. See the pictures.
Does anybody have an idea of the role of the capacitors, and the values of them.
Hydron:
I think the row of missing caps is normal (from memory of the innards of mine), but I could be wrong.
You at least have the newer chip which supports a higher number of counts (after EEPROM mods are applied).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version