Products > Test Equipment

A look at the Uni-T UT210E

<< < (135/177) > >>

001:
So long tread  :-+ UT210E was invented 6 years ago
What about new alternatives in 2019? (I.e. same performance and Low DCA range)

Few "noname" clamps based on the same chip but has 6000 counts in stock
Any opinions? I didn`t see "zero" or "range" button. Why?





TurboTom:
Except for the third one (which has a "Zero" button), the clamp meters shown are AC current only. Hence they don't need it.

001:
Thanx a lot
and what about ACM91 instead UT210E?

pratap_369:

--- Quote from: pratap_369 on June 12, 2019, 05:11:32 am ---My UT210E's current measurement are way off (around 300mA on 20A range and 150mA on 2A range) after I did the calibration (by pressing blue and yellow buttons while turning on the meter) .I did realize that I shouldn't have done that after reading the whole thread  :(. Is the calibration is the main reason that gives the inaccurate reading.I did clean the contacts of the selector wheel but  the readings are same.
could somebody help me out whats wrong?
here is my eeprom data

--- End quote ---


anybody have any clue?

001:

--- Quote from: Stinger on April 21, 2019, 09:13:56 pm ---I   hacked UT210E DM1106EN multimeter. 
I set :
9999 counts
2A ACA / DCA / ACA dotless / DCA dotless

--- End quote ---

Is it possible to get  9999mA range instead 2A?
What is maximum crest facktor for DM1106EN in 9999 mode?[/list]

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod