Products > Test Equipment

A look at the Uni-T UT210E

<< < (154/177) > >>

Mortymore:
It would be interesting to know if the regular 210E could be fitted with the Pro firmware, so it could be able to also measure frequency  ::)

EDIT: Or the 210E be changed to do it. What's the Pro controller chip?

DentDude:
Hi guys, I just performed the mod on my UT210E using the info in the latest JAY_i2cArduino210E.ino.  Everything works great.  Regarding the extra modes added to the NCV function, I've read the 2nd function is NCV with a mV display (added when address 9C is programmed with the value 02), but what is the third NCV function (added when address AC is programmed with the value 1D)?  That is not really described anywhere when I was reading through this thread.

brainwash:
It shows Amps instead of mVolts so perhaps it's the RMS current of the voltage detection module? It looks like the mV measurement but has different values, did not look into it. It also beeps at higher values, like the normal detection mode.

Stinger:

--- Quote from: Mortymore on October 30, 2020, 11:52:00 am ---It would be interesting to know if the regular 210E could be fitted with the Pro firmware, so it could be able to also measure frequency  ::)

EDIT: Or the 210E be changed to do it. What's the Pro controller chip?

--- End quote ---
The UT-211B can measure frequencies, and measure mA in 6000 counts with dot. Maybe different hardware.

SmokedComponent:
Has anyone hacked Voltcraft VC-330 yet? Just asking out of caution (is it really 100% same firmware/hardware as "original" UT210E) so that I don't brick it.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod