| Products > Test Equipment |
| A look at the Uni-T UT210E |
| << < (159/177) > >> |
| lnxpro:
I just got a UT210E Pro (the one with the black clamps). the chip inside is the same DM1106EN as in the non pro version. I attached the original bin file if anyone is curious. I was able to modify this the same way as the original non pro version (10k count, start on DC, endless power on and backlight) by flashing it. I used a clamp programmer. If anyone wants to look at the bin file I provided and compare it with an original from a non pro version, I'd be curious to see what the differences are :) |
| cdev:
I am going to give this a look. It sure would be a big time saver.. |
| Stinger:
--- Quote from: lnxpro on May 06, 2021, 07:38:00 pm ---I just got a UT210E Pro (the one with the black clamps). the chip inside is the same DM1106EN as in the non pro version. I attached the original bin file if anyone is curious. I was able to modify this the same way as the original non pro version (10k count, start on DC, endless power on and backlight) by flashing it. I used a clamp programmer. If anyone wants to look at the bin file I provided and compare it with an original from a non pro version, I'd be curious to see what the differences are :) --- End quote --- Hi, Original bin of UT210E VS Pro. How modify for adding Frequency... |
| jotte:
Hello, thank you all for sharing all that very nice findings! Got an UT210E Pro and also managed to modify it to much more useful settings. Thanks! --- Quote from: Stinger on May 16, 2021, 06:15:51 pm ---.... How modify for adding Frequency... --- End quote --- Mine has a 24C08 in it. So its 1024 Bytes instead of 256Bytes in a 24c02 used in the normal 210E. There are some additional entries from 0x160 to 0x175 . Maybe ... ;) |
| alex27riva:
Hi everyone, my UT210E doesn't work well, sometimes the current measurements (AC and DC) are completely wrong, and also the clamp resets when switching from one mode to another. The batteries are charged, they measure 2.8V with the clamp on (I measured with another multimeter). I read in this thread that the caliper can be modded, so I ordered an EEPROM programmer from Aliexpress in order to backup the settings and attempt a calibration. |
| Navigation |
| Message Index |
| Next page |
| Previous page |