| Products > Test Equipment |
| A look at the Uni-T UT210E |
| << < (172/177) > >> |
| Evgeniy:
--- Quote from: Neutrion on April 16, 2023, 12:31:51 pm ---Amps range is working sometimes, but sometimes not? --- End quote --- Doesn't work at all. --- Quote from: Neutrion on April 16, 2023, 12:31:51 pm ---You could also check the traces of the switch. --- End quote --- Looks like is good. --- Quote from: Neutrion on April 16, 2023, 12:31:51 pm ---And maybe trying the calibration method with the buttons, which also does some self test. --- End quote --- Calibration method with the buttons don't work. I tried it.. Nothing happens at all when the buttons are pressed... |
| Neutrion:
Most probably fried than. Interesting that it seems you didn't even find any damaged components. With a fully charged? big capacitor I would have expected some burn marks. Or was the PTC leg damaged in the accident? |
| Evgeniy:
--- Quote from: Neutrion on April 17, 2023, 11:40:58 am ---Interesting that it seems you didn't even find any damaged components. --- End quote --- Yes, very strange... --- Quote from: Neutrion on April 17, 2023, 11:40:58 am ---With a fully charged? big capacitor I would have expected some burn marks. --- End quote --- I thought too. --- Quote from: Neutrion on April 17, 2023, 11:40:58 am ---Or was the PTC leg damaged in the accident? --- End quote --- I think it happened during the installation process on the board...And as I told I tried to replace it on resistors of 15 Ohm - NO results. :-// |
| sofakng:
Hey guys, long thread so I apologize that I didn't read all of it. How is this amp meter for hobbyist use? I'm looking for a clamp to measure AC and DC (mostly DC for now). I've invested in a Fluke 87V (used) a while ago and I'm tempted to buy a used Fluke i410 clamp, but even used it's double the price of the UT210 and it requires the multimeter to be attached. Any thoughts or advice? |
| Grandchuck:
I guess it depends on your intentions. On dc current, how sensitive, top range and accuracty needed. Same on ac current plus what frequency range needed. |
| Navigation |
| Message Index |
| Next page |
| Previous page |