Products > Test Equipment
A look at the Uni-T UT210E
Evgeniy:
--- Quote from: Neutrion on April 16, 2023, 12:31:51 pm ---Amps range is working sometimes, but sometimes not?
--- End quote ---
Doesn't work at all.
--- Quote from: Neutrion on April 16, 2023, 12:31:51 pm ---You could also check the traces of the switch.
--- End quote ---
Looks like is good.
--- Quote from: Neutrion on April 16, 2023, 12:31:51 pm ---And maybe trying the calibration method with the buttons, which also does some self test.
--- End quote ---
Calibration method with the buttons don't work. I tried it.. Nothing happens at all when the buttons are pressed...
Neutrion:
Most probably fried than. Interesting that it seems you didn't even find any damaged components. With a fully charged? big capacitor I would have expected some burn marks. Or was the PTC leg damaged in the accident?
Evgeniy:
--- Quote from: Neutrion on April 17, 2023, 11:40:58 am ---Interesting that it seems you didn't even find any damaged components.
--- End quote ---
Yes, very strange...
--- Quote from: Neutrion on April 17, 2023, 11:40:58 am ---With a fully charged? big capacitor I would have expected some burn marks.
--- End quote ---
I thought too.
--- Quote from: Neutrion on April 17, 2023, 11:40:58 am ---Or was the PTC leg damaged in the accident?
--- End quote ---
I think it happened during the installation process on the board...And as I told I tried to replace it on resistors of 15 Ohm - NO results. :-//
sofakng:
Hey guys, long thread so I apologize that I didn't read all of it.
How is this amp meter for hobbyist use? I'm looking for a clamp to measure AC and DC (mostly DC for now).
I've invested in a Fluke 87V (used) a while ago and I'm tempted to buy a used Fluke i410 clamp, but even used it's double the price of the UT210 and it requires the multimeter to be attached.
Any thoughts or advice?
Grandchuck:
I guess it depends on your intentions. On dc current, how sensitive, top range and accuracty needed. Same on ac current plus what frequency range needed.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version