Products > Test Equipment

Absolute Best MultiMeter Test Leads - Very Low Resistance?

<< < (18/18)

Fungus:

--- Quote from: MtnMike on December 25, 2024, 05:55:36 pm ---I then measured the leads again after running 10A through them and now they both seem to be good and measure about 0.04 ohms. 

--- End quote ---

They just needed to be burnt in.  :)

indeterminate:
I think that they are just badly crimped
I have a pair that if you hang onto the probe and lead and give them a little tug the resistance drops

bdunham7:

--- Quote from: indeterminate on December 26, 2024, 02:11:38 am ---I think that they are just badly crimped
I have a pair that if you hang onto the probe and lead and give them a little tug the resistance drops

--- End quote ---

Probe Master solders their test lead for this very reason.

5U4GB:

--- Quote from: Fungus on December 25, 2024, 10:33:44 pm ---
--- Quote from: MtnMike on December 25, 2024, 05:55:36 pm ---I then measured the leads again after running 10A through them and now they both seem to be good and measure about 0.04 ohms. 

--- End quote ---

They just needed to be burnt in.  :)

--- End quote ---

Just be aware that the process makes them directional so from now on you can only use them to measure DC currents and voltages.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod