| Products > Test Equipment |
| Accidently removed the firmware in Tektronix TDS 350, can it be loaded back? |
| (1/1) |
| deviantlogic:
Hi everyone, First post here in this forum. (been reading for years obv). >:D Anyway, I really fucked up today. I recently bought a perfect condition Tektronix TDS 350 oscilloscope, and today while i was just poking around in the scope menus i accidentally removed the whole front panel software by clicking on "OK Erase Setup & Ref Memory" reference from the manual here on page 99: http://ecelabs.njit.edu/student_resources/tds320.pdf?fbclid=IwAR0IH8HTQbrhA_knptBkp25q1BKkoc0FNBehWnyATqBS47JsphjQYKT9sYY Now the scope is essentially just acting like a bad version of a analog oscilloscope, i can see waveforms when sending signals into CH 1 and CH 2 but ALL menus are gone, cant access anything. I need help guys, anyone experienced in reloading the firmware into these scopes? Or should i just give up on this and just buy a new scope and NEVER do this again. Thanks EDIT EDIT EDIT: I solved the problem. By removing a user setup the scope reverted to a setting where the display intensity and contrast was set to 0% somehow. Puh!!! the scope is still alive. |
| Navigation |
| Message Index |