Products > Test Equipment

Accurate Low Amp Current Probe Advice

<< < (25/56) > >>

KungFuJosh:
Holy shit, Batman! Martin, when you said this thing was big, I had no idea how ridiculous it is. 🤣🤣🤣



Only problem is that the probe that came with the set has a small issue with the switch.  |O

tautech:

--- Quote from: KungFuJosh on November 02, 2024, 07:13:33 pm ---Only problem is that the probe that came with the set has a small issue with the switch.  |O

--- End quote ---
Which forms part of the jaw locking device.......

Martin72:
I still have a few parts... 8)

KungFuJosh:
I set the SDG2122X output to 369mV at 1kHz, and that measured 5.00mA on my SDM3065X.

Then I setup the AM503B at 1mA/DIV with 20M limit.

This looks pretty good, right? Did I do anything stupid in my setup? 🤔

...because after reconnecting to the SDM, I'm getting 1.713mA. I assume there's an equation I should know here. 😉

Martin72:
As I mentioned before, you set 10mV/div, 1:1 and 50Ohm on the scope itself and leave it as it is.
Everything else (bandwidth limitation, scaling, AC, DC) is set on the 503B.


--- Quote ---I set the SDG2122X output to 369mV at 1kHz, and that measured 5.00mA on my SDM3065X.

--- End quote ---

So you used a 73.8 ohm resistor as a load?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod