Products > Test Equipment

Adding fuse to cheap Chinese multimeter: DT830X

<< < (4/4)

Fungus:

--- Quote from: NoisyBoy on May 13, 2023, 05:43:22 am ---Looking at the input sockets, I don’t know what is on the bottom half of the case to keep it in place. I tend to think each insertion and removal would stress the single solder point.

--- End quote ---

Yeah, those are really crappy connectors.


(also zero strain relief on the battery cables - I garantee they'll break off if you open the meter up a few more times to play with it...)

Compare with the $4 "Big Clive" version:


Fungus:
Gotta hand it to them though, they managed to make the PCB smaller than the diameter of the selector switch - the dial sticks out on both sides:



Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod